ID Press Inc. builds heat presses for print shops, apparel brands and makers growing a business. We care about three things, and we design every machine around them.
Even heat
The same temperature in every corner of the platen, so prints come out the same every time.
Steady pressure
The first shirt and the five hundredth get exactly the same squeeze.
Real support
A free video call to set up your press, and people who answer when you need help.
Your first press day
Here is what the first 30 minutes look like.
Tap each step. This is the Machine #A, the AutoClam is even quicker.
Minute 0
Lift it out and set it down
Your press arrives on a pallet with everything inside one box. Two people lift it onto a sturdy bench. No assembly needed.
Press, platen and silicone pad
Air hose, Teflon sheet and power cord
Quick start card with a setup video link
Minute 10
Plug in power and air
Plug into a 220V outlet, click the air hose onto your compressor and switch on. The platen reaches 400°F in about 12 minutes while you finish setting up.
220V outlet for the AirSwing
Compressor set to 60 to 100 psi
Watch the pressure gauge settle
Minute 18
Pick a preset on the screen
Tap the material you are pressing. We load starter presets for DTF, HTV and sublimation, and you can save up to 10 of your own.
DTF on cotton: 300°F, 15 s, medium
HTV: 315°F, 12 s, medium
Sublimation: 400°F, 45 s, light
Minute 30
Press your first shirt
Slide the drawer out, lay the shirt and transfer, slide in and swing the platen over. The press opens on its own when the timer ends. Peel and admire.
Lay out away from the heat
Auto-open when the timer ends
Load the next one in seconds
Two presses at launch
Pick the press that fits your day.
For busy shops
Machine #A
100+ pieces a day
Hoodies
Totes
Sublimation
Air does the pressing for you, so your arms stay fresh at the end of a long run. The top swings away and the base slides out, so you lay out every shirt far from the heat.
Machine #A press, 16 x 20 in lower platen with silicone pad, air hose and quick coupler, Teflon sheet, power cord, and a quick start card. Needs a 220V outlet and a compressor that holds 60 to 100 psi.
For small spaces
Machine #B
Side business
Event booths
Custom orders
Standard outlet
A real professional press that fits on a desk and plugs into any wall outlet. When the timer ends, it opens on its own, so a transfer never overcooks while you trim the next one.
